Rinnai RHFE-308FTR How To Use Manual page 15

Before programming the Timers you must ensure that the clock has been set to the correct time.
As an example let's programme Timer 1 to heat the room by 7:lO AM and finish at 9:OO AM.
Press the Set Times button twice. The Digital
Display will show AM 6:O0. Timer 1 indicator
will flash.
1
Press the "A" button until AM
release the button, then press
AM 7:lO appears. (Press the
you go past AM 7: 10.)
7:OO appears,
it again until
"V" button if
n
3
Press the Set Times button again, the Timer 1 OFF
indicator will flash. Press the "A" button until
AM 9:OO appears.
cl
4
Press the Set Times button three times to lock in
the programmed time. The Digital Display will
show the current time. A small indicator on the
Digital Display will flash to show that the Display
has returned to the clock.
TURN TO NEXT PAGE TO OPERATE THE TIMERS.
TIMER 2 is programmed in the same way, remember to ensure that the Timer 2 indicator is flashing
when you programme in the desired setting.
The Timers can be programmed to operate for any two periods in any 24 hours. Turn to next page
to operate the dual timer.
The programmed time must be selected and locked-in within one minute of the On Timer
indicators flashing otherwise the programmed times will not be retained in the system memory.
-14-