SEVERIN S2+ One Touch Instruction Manual page 64

Display Cause
There is not enough
WATER SUP-
water in the brewing
PLY ERROR.
unit.
GB
A system error oc-
SYSTEM ER-
curred.
ROR. PLEASE
RESTART.
The grinder is
GRINDER
blocked.
BLOCKED.
CONTACT
SERVICE.
A system error oc-
SYSTEM ER-
curred.
ROR. CONTACT
SERVICE.
64
Remedy
Clean the water tank and
especially its water discharge
on the floor.
Fill the water tank halfway
with cold drinking water and if
necessary, remove the water
filter and replace it.
If problem persists, also clean
the brewing unit (►"8.3
Cleaning the brewing unit").
Switch the device off for sev-
eral seconds and then switch it
on again.
Set the grinder regulator on
the coarsest fineness (►"7.1
Setting the grinding fineness")
and prepare another coffee
speciality.
If this solves the problem, set
the desired fineness again for
the next beverage.
If problem persists, contact
customer service.
Call customer service.
Display Cause
There is too much
TOO MUCH
coffee in the brewing
COFFEE.
unit.
CANCEL
There is too little
TOO LITTLE
coffee in the brewing
GROUND COF-
unit.
FEE.
CANCEL
Remedy
Clean the brewing unit (►"8.3
Cleaning the brewing unit").
In the future, set a higher
fineness (►"7.1 Adjusting the
grinding fineness").
When you have added ground
coffee via the powder dosing
chamber, reduce the amount
of coffee powder which you
are putting in for a cup portion.
Clean the brewing unit (►"8.3
Cleaning the brewing unit").
In the future, set a coarser
fineness (►"7.1 Adjusting the
grinding fineness").
When you have added ground
coffee via the powder dosing
chamber, increase the amount
of coffee powder which you
are putting in for a cup portion.
Version 3 2012-08