Changing The Water Filter - SEVERIN S2+ One Touch Instruction Manual

NOTE!
– The descaling process can take as long as 30
minutes.
– No warranty is made for damage that is due to
devices which have not been descaled regularly.
– If you descale immediately after the display
of a cleaning message, steps 1 and 2 can be
omitted.
– If you use a water filter, remove it before descal-
ing.
GB
1. Press the menu button for at least 3 seconds and use the e-Select to
select the
CLEANING
menu option.
2. Then select the
DESCALING
menu option and press the e-Select.
The display shows:
Â
PLEASE EMPTY GROUNDS CONTAINER
3. Remove the drip tray and empty it together with the grounds container.
4. Re-assemble all parts and push the drip tray back into the device.
5. Press the e-Select to continue.
The display shows:
Â
PLEASE ADD DESCALING SOLUTION
6. Fill the water tank halfway with lukewarm tap water and place the des-
caling tablets in the water tank.
7. Wait until the descaling tablets are completely dissolved and then place
the water tank on the device.
60
8. Press the e-Select to continue.
The display shows:
Â
DESCALING
9. As soon as the command
EMPTY DRIP TRAY
appears on the display, empty the drip tray and grounds container again.
Clean the parts with clear tap water and reinsert them into the device.
10. Press the e-Select to continue.
The display shows:
Â
RINSE CONTAINER AND FILL WITH WATER
11. Rinse the water tank thoroughly with clear tap water, then fill it to the top
and put it back on the device.
12. Press the e-Select to continue.
The display shows:
Â
DESCALING
The descaling is complete as soon as "Beverage selection" ap-
pears again..

8.2.6 Changing the water filter

For constant water quality, the water filter must be changed regularly.
NOTE!
If you change the water filter immediately after the
display of a cleaning message, steps 1 and 2 can
be omitted.
1. Press the menu button for at least 3 seconds and use the e-Select to
select the
CLEANING
menu option.
Version 3 2012-08