Filter Setting - Delta 29FWC-100E Instruction Manual

Deactivation of the "Blow" Function: The activated "Blow" function can be deactivated by firstly
pressing the Function button to select the "Blow" option and then pressing the Enter/Cancel button.
BLOW function setting is as shown in Fig.22:
Unit On, no Blow function
Notes:
When the "Blow" function is activated, if the unit is turned off through the On/Off button, the
① .
indoor fan will still run at low fan speed for another 10 minutes. When the "Blow" function is
deactivated, the indoor fan will stop directly as the unit is turned off.
The "Blow" function is not available in the FAN and HEAT modes.
② .

3.17 Filter Setting

Under On status, press "Function" button to set "Filter" function with "Filter" icon flashing. The
setting pollution level will be shown at the Timer area. Press "▲" and "▼" to adjust pollution level
and press "Enter/Cancel" button to activate Filter function.
When the Filter function is set, press "Function" button to set with "Filter" icon flashing. Press "▲"
and "▼" to adjust till "00" is shown on the timer area. Then press "Enter/Cancel" button to cancel
the Filter function.
How to set Filter function is shown in the Fig.23:
Press "Function" button to set
blow function
Press "Enter/Cancel" button to
cancel blow function
Fig.22 Blow Function Setting
19
Press "Enter/Cancel" button to
activate blow function
Press "Function" button to set
blow function