How To Remove The Wired Controller; Error Display - Delta 29FWC-100E Instruction Manual

Brief instructions:
Pull out the 2-core signal line from the mounting hole and pass this line through the round
① .
hole located at the bottom of the wired controller.
Use M4×25 screws to
② .
Fix the signal line on the copper tabs X1 and X2. Make sure the line is tightly fixed and with
③ .
no short-circuit
Set the panel and the bottom together by clasps.
④ .

4.4 How to Remove the Wired Controller

The wired controller can be easily removed as shown in Fig.28

5 Error Display

When error happens to the unit, the error code will be shown on the wired controller. When
multiple errors simultaneously happen, the error codes will circularly show up.
When error occurs, please immediately shut down the unit and contact professional personnel.
As shown in the Fig.29 means the high pressure protection.
fix the soleplate of the wired controller on the wall.
potential.
Fig.28 Removal of the Wired Controller
Fig.29
26