Unable To Specify Desired Settings Or Unable To Print As Specified - Konica Minolta bizhub 350 Quick Manual

6
6.2 Unable to specify desired settings or unable to print
as specified
Perform these troubleshooting procedures if you cannot specify the desired
settings in the printer driver, or if the print results do not represent the set-
tings that have been specified.
Note
Some of the printer driver functions cannot be combined with other func-
tions.
Symptom
A printer driver setting
cannot be selected.
The "Conflicts" message
with "Unable to Select" or
"Function Canceled" ap-
pears.
Printing is not performed
as specified.
The watermark cannot be
printed.
The staple function can-
not be specified.
Stapling cannot be per-
formed.
6-4
Probable cause
Some functions cannot be com-
bined.
An incorrect combination of
functions has been specified.
Incorrect settings are specified.
A combination of functions, al-
though possible in the printer
driver, is not possible with this
machine.
The paper size, orientation, and
other settings specified in the
application have priority over
those specified in the printer
driver.
The watermark is not correctly
set.
The watermark density is set to
a level that is too low.
Watermarks cannot be printed
in graphics applications.
Stapling is not possible if "Paper
Type" is set to "Thick" or
"Transparency".
The staple function requires op-
tional finisher.
If there are a large number of
pages to be printed, stapling
cannot be performed.
Stapling is not possible if the
document contains pages of dif-
ferent sizes.
Troubleshooting
Action
Do not try to select settings that
are not available.
Check the settings and specify
the functions correctly.
Check each setting in the printer
driver.
Enter the correct settings in the
application.
Check the watermark settings.
Check the density settings.
No watermark can be printed in
this case.
Check each setting in the printer
driver.
Install the required optional fin-
isher and enable it using the
printer driver.
Print by specify the number of
pages per set for the number of
pages that can be stapled.
Check the document.
200/250/350