Generalmaintenance - SOLE 16608600950 Owner's Manual

GENERALMAINTENANCE

1. Wipe down all areas in the sweat path with a damp cloth after each workout.
2. If a squeak, thump, clicking or rough feeling develops the main cause is most likely one of two reasons:
I. The hardware was not sufficiently tightened during assembly. All bolts that were installed during
assembly need to be tightened as much as possible. It may be necessary to use a larger wrench than
the one provided if you cannot tighten the bolts sufficiently. I cannot stress this point enough; 90% of
calls to the service department for noise issues can be traced to loose hardware or the rear rails being
dirty.
II. Dirt build-up on the rear rails and polyurethane wheels are also a source of noise. Noise from build-up
on the rails can cause a thumping sound that you would swear is coming from inside the main body of
the machine because noise travels, and is amplified in the tubing of the frame. Clean the rails and
wheels with a lint free cloth and rubbing alcohol. Stubborn build-up can be removed with your
thumbnail or a non-metallic scraper, like the back edge of a plastic knife. After cleaning, apply a small
amount of lubricant on the rails with your fingers or a lint free cloth. You only need a thin coat of
lubrication, wipe off any excess.
3. If squeaks or other noises persist, check that the unit is properly leveled before calling the service
department.
MAINTENANCE MENU IN CONSOLE SOFTWARE
The console has built in maintenance/diagnostic software. The software will allow you to change
the console settings from English to Metric and turn off the beeping of the speaker when a key is
pressed for example. To enter the Maintenance Menu (may be called Engineering Mode, depending
on version) press and hold down the Start, Stop and Enter keys keep holding the keys down for
about 5 seconds and until the display shows display"Engineering Mode". Press the Enter button to
access the menu below. Press the Level
A. KEY TEST - Will allow you to test all the keys to make sure they are functioning.
B. UNIT MODE - Choose from English or Metric display readings.
C. MANUAL TEST - Allows stepping of the gear motor.
D. DISPLAY MODE - Turn off to have the console power down automatically after 30 minutes of
inactivity.
E. PAUSE MODE - Turned on to allow 5 minutes of pause, turn off to have console.
F. KEY TONE - Turn on or off the beep sound when a key is pressed.
G. CHILD LOCK - Allows you to lock the keypad so no unauthorized use of the machine is allowed.
When the child lock is enabled, the console will not allow the keypad to operate unless you
press and hold the Start and Enter buttons for 3 seconds to unlock the console.
Dyaco Canada Inc. 2016
keys to navigate the menu.
▲/▼
32 customerservice@dyaco.ca