SOLE E55 Assembly Instructions Manual

PRINT
Delivery Requirements
• Ground delivery
•
Inside delivery to customer-specified location
•
Unpack and assemble machine, and remove packing materials
1. Unload the carton from the trailer and take it to the
customer-specified location using a two-wheeled dolly.
When moving the carton, be sure to use safe lifting
procedures. Be sure to bend at the knees and keep your
back straight.
3. Review the assembly instructions.
Inside the carton, you will find the Owner's Manual. It will be necessary for you to follow the manufacturer's assembly instructions to
be able to complete the assembly of the Sole Fitness E95 Elliptical Trainer.
Do not attempt to assemble this machine without the Owner's Manual.
4. Install the incline rail assembly into the U-channel bracket of the main frame.
Place the incline rail
Assembly into the U-channel
on the main frame.
(This is shown in Step 1.1 and 1.2 on page 8 of the Owners Manual)
5. Attach the console mast and console mast cover to the main frame.
Slide console mast Pull the cable out
cover onto the of the top of the
mast. main frame and
unravel and
straighten out.
6. Attach the console to the console mounting plate.
Sole Fitness E95 Elliptical Trainer
TurnKey® Delivery and Setup Training
Install four bolts, split Install two bolts
washers, and star and two nylon nuts
washers into the top of into the sides of
rail assembly. the U-channel.
Feed the cable into
the bottom of the
console mast and
out the top.
(This is shown in Step 1.2 and 1.3on page 8 in the Owner's Manual.)
Tools Required
• Liftgate
•
Two-wheel dolly
• Cutters to cut plastic banding
2. Unpack the contents of the cartons and remove
Note: Some deliveries
all packing materials.
will require setup in an
upstairs room or other
location with limited
access. When this is
the case, it is recom-
mended that you
unpack the parts
outside and carry
them individually to
Cut along the
the customer-speci ed
location. bottom edge
of the carton.
Connect the three incline motor power lines and
the 3-pin position sensor connector on the main
frame to the corresponding ones on the incline
rail assembly.
Be careful not to pinch or cut the wires.
Install the mast into
the receiving
bracket on the
main frame.
Place the console next to the console mast plate, and then plug all of
the connectors into the back of the console.
Secure the console to the console mounting plate with four Phillips
head screws.
Be careful not to pinch or cut the wires.
(This is shown in Step 1.4 on page 8 in the Owner's Manual.)
Remove all
packing material.
Install one long Install two short hex
hex bolt and split head bolts and curved
washer into the washers into the front
side of the bracket of the console mast.
and mast.
Locate the
hardware
packet.