Omron E5CN Manual page 55

SECTION 3 Communications Data for CompoWay/F and SYSWAY
Vari-
Ad-
able Parameter name
dress
type
C3 004C Protocol Setting
(See note 3.)
C3 004D Send data wait time
(See note 3.)
C3 004E Control output 1
assignment
C3 004F Control output 2
assignment
C3 0050 Alarm 1 assignment
C3 0051 Alarm 2 assignment
C3 0052 Display character
switch
C3 0053 Program pattern
C3 0054 Soak time units
C3 0055 Alarm SP selection
Note 1. Not displayed on the Controller display.
Note 2. The parameter will not be shown on the Controller display when alarm 3 is not assigned to an
output.
Note 3. After communications parameters have been changed, they are enabled by resetting the
Controller.
Note 4. The setting (monitor) range depends on the "transfer output type" setting. (See the setting data
list for details.)
Note 5. The program end output can be set when the "program pattern" is not set to 0 (OFF).
Note 6. Program start can be set when the "program pattern" is not set to 0 (OFF).
Note 7. The logic is switched only in the MB command (SYSWAY). The logic of CompoWay/F operation
command code 00 (communications writing) is not influenced.
3-14
Setting (monitor) value
H'00000000 (0): CompoWay/F (SYSWAY)
H'00000001 (1): Modbus
H'00000000 to H'00000063 (0 to 99)
When control output 1 is a linear output:
H'00000000 (0): Not assigned.
H'00000001 (1): Control output (heating)
H'00000002 (2): Control output (cooling)
When control output 1 is a pulse output:
H'00000000 (0): Not assigned.
H'00000001 (1): Control output (heating)
H'00000002 (2): Control output (cooling)
H'00000003 (3): Alarm 1
H'00000004 (4): Alarm 2
H'00000005 (5): Alarm 3
H'00000006 (6): Program end output (See note 5.)
H'00000000 (0): Not assigned.
H'00000001 (1): Control output (heating)
H'00000002 (2): Control output (cooling)
H'00000003 (3): Alarm 1
H'00000004 (4): Alarm 2
H'00000005 (5): Alarm 3
H'00000006 (6): Program end output (See note 5.)
H'00000000 to H'00000006 (0 to 6)
* Same settings as control output 2 assignments
H'00000000 to H'00000006 (0 to 6)
* Same settings as control output 2 assignments
H'00000000 (0): OFF
H'00000001 (1): ON
H'00000000 (0): OFF
H'00000001 (1): STOP
H'00000002 (2): CONT
H'00000000 (0): Minutes
H'00000001 (1): Hours
H'00000000 (0): Set point during SP ramp
H'00000001 (1): Set point
Level
Commu-
nications
setting
Advanced
function
setting
Initial set-
ting
Advanced
function
setting