VTech VSP600A Quick Start Manual page 15

Wall mounting the charger
The charger is ready for tabletop use. If you want to mount the charger on a wall, use
two 10 mm (3/8 inch) screws and wall anchors to hold the charger in place. Screws
and wall anchors are not provided, but are available for purchase in many hardware or
consumer electronics retailers. You might need a professional to install the charger.
To mount the charger on the wall:
1. Use a pencil to mark the desired positions of the two holes on the wall, make sure
the space between the two holes is 30 mm (1 3/16 inches). Drill two holes in the
wall according to the marks.
2. If you drill the holes into a stud, go to step 3.
-OR-
If you drill the holes into an object other than a stud,
insert the wall anchors into the holes and tap gently on
the ends with a hammer until the wall anchors are flush
with the wall.
3. Insert the screws into the holes and tighten them until
only 6 mm (1/4 inch) of the screws are exposed.
4. Align the holes at the back of the charger with the
screws on the wall and slide the charger down until it
locks into place.
Screw spacing 30 mm
(1 3/16 inches)
15