Panasonic WJ-FS316 Operating Instructions Manual page 35

3. Press the SPOT/MULTISCREEN button so that the LED
of SPOT/MULTISCREEN button goes off.
4. Press a CAMERA SELECT button to display a camera
playback picture on the monitor screen.
The LED on the pressed CAMERA SELECT button
lights up, and the selected playback picture appears
on the monitor.
2. Still Spot Playback Picture
1. Repeat the procedures described above for Spot
Playback Picture.
2. Press the STILL button to freeze the displayed picture.
The LED on the STILL button lights up, and the LED on
the pressed CAMERA SELECT button starts to blink.
The camera title and "STILL" (both blinking) alternate in
the display.
3. To cancel the still picture, press the STILL button
again.
The LED on the STILL button goes off and the selected
playback picture is displayed in spot mode.
STILL
Note: The VCR continues playback while the still pic-
ture is displayed on the monitor screen.
35
ENTRANCE
Playback Picture
STILL
3. Zoomed Spot Playback Picture
1. Repeat the procedures described above for Spot
Playback Picture.
2. Press the EL-ZOOM button to display the zoomed pic-
ture. The "+" sign appears in the picture.
Note: The "+" sign disappears if no operation is per-
formed within approx. 5 seconds. If the "+" sign dis-
appeared, press the EL-ZOOM button again so that
the "+" sign appears in the picture.
EL-ZOOM
3. Press the cursor buttons (C, D, A, B) to move the
zoomed area within the picture.
4. Press the + button to zoom in, or – button to zoom out.
Notes:
• When the + button is pressed, the picture is
zoomed twofold.
• The picture cannot be zoomed out to be smaller
than the original size by pressing the – button.
5. To cancel this mode, press the – button or the EL-
ZOOM button. The selected playback picture is dis-
played in normal size in spot mode.