Monitor Output Setup Menu - Panasonic WJ-FS316 Operating Instructions Manual

9. MLT OUT MODE
This item lets you select whether to switch the multiscreen
output monitor screen automatically to the camera picture
of the channel whose alarm is activated.
1. Move the cursor to the MLT OUT MODE parameter.
2. Select OFF or SPOT by pressing the + or – button.
The initial factory setting is SPOT.
OFF: Ignores alarm activation and continues to display
the pictures in the mode selected previously. All
buttons except alarm reset button do not valid on
condition that alarm reset does not complete.
SPOT: The camera picture whose alarm is activated is
displayed and retained until the alarm is reset.
10. SPT OUT MODE
This item lets you select whether to switch the spot output
monitor screen automatically to the camera picture of the
channel whose alarm is activated.
1. Move the cursor to the SPT OUT MODE parameter.
2. Select OFF or SPOT by pressing the + or – button.
The initial factory setting is SPOT.
OFF: Ignores alarm activation after and continues to
display the pictures in the mode selected previous-
ly. All buttons except alarm reset button do not valid
on condition that alarm reset does not complete.
SPOT: The camera picture whose alarm is activated is
displayed and retained until the alarm is reset.
13

Monitor Output Setup Menu

1. MULTI OUTPUT
WJ-FS316 SETUP
ALARM SETUP
MONITOR OUTPUT SETUP
REC OUTPUT SETUP
SEQUENCE SETUP
SYSTEM SETUP
Move the cursor to MONITOR OUTPUT SETUP on the
SETUP menu, then press the SET button. The MONI-
TOR OUTPUT SETUP menu appears on the monitor
screen as shown below.
MONITOR OUTPUT SETUP
MULTI OUTPUT
TITLE DISP
STILL DISP
BORDER
QUAD SHIFT
SECRET VIEW
SPOT OUTPUT
TITLE DISP
1-1. TITLE DISP
This item lets you enable or disable the camera title display
overlaid on the multiscreen picture.
1. Move the cursor to the TITLE DISP parameter.
2. Select ON or OFF by pressing the + or – button.
The initial factory setting is ON.
ON: Enables display of the camera title.
OFF: Disables display of the camera title.
1-2. STILL DISP
This item lets you enable or disable the subtitle "STILL"
overlaid on the multiscreen output picture.
1. Move the cursor to the STILL DISP parameter.
2. Select ON or OFF by pressing the + or – button.
The initial factory setting is ON.
ON: Enables display of the subtitle "STILL".
OFF: Disables display of the subtitle "STILL".
ON
ON
WHITE
OFF
OFF
ON