Advertisement
BB-HCM371
Multi-Camera Setup Supported
Simultaneous monitoring of images using up to four
network cameras. Images from up to four camera units
can be assigned as a group, and the monitor display can
be switched to any of three image groups. This enables
simultaneous display of the images from up to 12
camera units, with no audio.
Alarm-Controlled and Timer-Controlled
Image Transfer Functions
The Alarm-Controlled Image Transfer function uses a
commercially available external Sensor or switch and
sends the image only when there is an action such as
turning on the light or opening the door. The Timer-
Controlled Image Transfer function automatically
transmits images according to the set time zone and
the day of the week. These convenient functions
eliminate your need to constantly check the image.
*When e-mail function is used to transfer images or messages, e-mail
transmission may not be possible in some cases due to the mail server
authentication system (SMTP authentication, etc.) used by your
Internet service provider.
*The image transfer functions can be used only with a PC. With a cell
phone, only the e-mail transmission function can be used.
Supporting Viewnetcam.com service
Viewnetcam.com service allows you to access the
camera over the Internet with your favorite domain
name (e.g. bob.viewnetcam.com) instead of a global
IP address. For more information on Viewnetcam.com
service, Please access
www.viewnetcam.com
for more information.
External Output Control
This provides ON/OFF operation of an externally
connected device. For example, it can be used to turn
on a light when the surrounding area becomes dark or
to turn on a buzzer in case of an emergency.
Pan and Tilt Movement
Pan
(173° maximum)
Tilt
(105° maximum)
Lens cover
Antenna
Lens
RESET
button
SD Memory
Card slot
Factory
Default
Button
AC adaptor
connector
Microphone
Indicator
I/O connector
Stand/tripod mounting section
*The photo shows the camera unit without the cover.
http://panasonic.co.jp/pcc/products/en/netwkcam/
Network Camera
IPv6-Ready
Our new network cameras allow the use of a virtually
unlimited number of IP addresses*
IPv6, a next-generation protocol. The IPv4/IPv6 dual-
stack feature enables you to use IPv4 at the present
and switch over to IPv6 in the future.
1
*
This logo mark is issued by the IPv6 Ready Logo Program Committee, an IPv6 promotion group established mainly by the IPv6 Forum.
2
*
This function can be used with a PC only. It cannot be used with a cell phone. To hear the voice transmitted from the PC, a commercially available
speaker with a built-in amp must be installed. The transceiver system does not allow simultaneous transmission and reception of voices.
The BB-HCM371 may require a version upgrade to operate in the IPv6 environment.
For the latest information, visit Panasonic's support Web site (http://panasonic.co.jp/pcc/products/en/netwkcam/).
*
3
An IP address is a unique number assigned to each user so that the user can be identified on the Internet.
4
*
IPsec is an IP security protocol for data encryption standardized by IETF, an international community devoted to the standardization of Internet
specifications.
Specifications of BB-HCM371 Network Camera
Model No.
Product type
Image data compression system
Resolution
Image quality
1
Frame rate*
Security
Encryption algorithm
IPsec function*
Supported protocol
User access limit
Buffered images*
Viewing Angle
Pan
Tilt
Revolving speed
Number of pixels
Lens focal point
Lens brightness
Required light intensity
Voice direction
Voice data compression system
Voice band
Audio input
Audio output*
5
Standards
Antenna
Number of Channel
Transmission Speed
Max. Transmission Distance
Security
Network Interface
I/O connector for sensor
SD Memory Card slot
Operating temperature
Operating humidity
Dimensions (W x H x D)
Weight
Power Supply
Consumption
*
1
This varies depending on the subject, image quality, network environment, PC performance, etc.
*
2
The image update speed may decrease when favor-motion mode is set, when images are recorded onto an SD Memory Card, and when IPsec is
used, as well as due to the network environment and PC performance.
*
Transport mode (mode for IPsec communication between terminals, for IPv4 only) operating environment: Microsoft
3
or later only, tunnel mode (mode for IPsec between VPN routers, IPv4/IPv6)
*
4
The number of images that can be stored varies depending on the subject. *
Specifications for Compatible PC
Stand mounting section
OS
External
CPU
microphone
input terminal
Protocol
Audio output
terminal
Interface
Web browser
Ethernet connector
(10/100Base-T(X))
Audio
3
by supporting
Outdoor, Wireless type and voice function
JPEG (Motion JPEG for moving image display)
640 x 480, 320 x 240, 160 x 120
3 modes (Favor Clarity, Standard, Favor Motion)
Max. 30 frames/sec (320 x 240, 160 x 120), Max. 12 frames/sec (640 x 480)*
User ID, password, IPsec
DES-CBC, 3DES-CBC, AES-CBC
3
ESP encryption, EPS authentication, transport mode (main mode only)/tunnel mode
IKE (Internet Key Exchange)
IPv4/IPv6 dual stack
IPv4: TCP, UDP, IP, HTTP, FTP, SMTP, DHCP, DNS, ARP, ICMP, POP3, NTP, IPsec, UPnP
IPv6: TCP, UDP, IP, HTTP, FTP, SMTP, DNS, ICMPv6, POP3, NDP, NTP, IPsec
Max. 30 simultaneous accesses (max. 10 accesses with voice reception)
4
Approx. 125 images: (320 x 240), standard image quality
(approx. 16 KB per image) (without using SD Memory Card)
53° horizontal (total 173°)
40° vertical (total 105°)
–60° up to +60°
–45° up to +20°
Pan: Max. 80°/sec, Tilt: Max. 80°/sec
1/4 inch, approx. 320,000 pixels, CCD sensor
Fixed (focal range: 0.5 m to ∞)
F3.5
3 to 100,000 lx (in Color Night View mode: 0.2 to 100,000 lx)
Half-duplex two-way communication (transceiver system)
ADPCM 32 kbps
300 Hz ~ 3.4 kHz
Built-in microphone or external microphone (sold separately), external microphone input
terminal (3.5-mm dia. mini-jack)
Audio line output terminal for external speaker
(3.5-mm dia. stereo mini-jack, monaural output)
802.11 b/g
Diversity
11 ch.
up to 54 Mbps.
Indoor: About 120 m, Outdoor: About 600 m
WEP 64/128/152 bit
Ethernet (10Base-T/100Base-TX)
G GND
1 External Senser Input
G GND
2 External Senser Input
3 External Device Control Output
4 DC Power Output Terminal (10.5–13.5V DC)
Full size (operation guaranteed for 1GB, 512MB, 256MB, 128MB and 64MB SD Memory Cards)
–20°C to 50°C
20% to 90% (No condensation)
Approx. 100 x 100 x 80 mm (Only the unit)
350 g (Only the unit)
AC adaptor: Input 120V AC, Output 12V DC
10W
For IPv4
®
Microsoft
Windows
®
Windows
®
Me, Windows
• For monitoring of image from one camera unit: Pentium RIII (800 MHz or greater)
• For monitoring of images from multiple camera units: Pentium R4 (1.8 GHz or greater)
TCP/IP (HTTP, TCP, UDP, IP, DNS, ARP,
ICMP) protocol must be installed.
Audio input/output function (microphone, speaker, etc.)
Design and specifications are subject to change without notice. 10M0205SK-HCM371-LT.X Printed in Japan
IPsec*
Supported
4
IPsec is a technology used to encrypt data packets in
order to prevent eavesdropping by third parties. When
combined with a conventional authentication function
based on user names and passwords, IPsec offers
enhanced security.
BB-HCM371
5
Install an amp or use a speaker with a built-in amp.
®
XP, Windows
2000,
Microsoft
Windows
®
®
98SE
or later
TCP/IP (HTTP, TCP, UDP, IP, DNS, ICMPv6,
NDP) protocol must be installed.
10/100-Mbps LAN card must be installed.
Internet Explorer 6.0 or later
2
®
®
Windows
XP Service Pack 1
For IPv6
XP, Service Pack 1
®
Advertisement
