Operating Instructions explains about operations, settings, features and the cleaning method when using the camera. Please read this manual before using and save this manual for future reference. Panasonic Network Camera Website: http://www.panasonic.com/netcam/ for customers in the USA or Puerto Rico...
Page 2
Installation/Troubleshooting Abbreviations • UPnP is the abbreviation for Universal Plug and Play. • "Network Camera" is called "Camera" in this Installation/Troubleshooting. Trademarks • Ethernet is either a registered trademark or a trademark of Xerox Corporation in the United States and/or other countries. •...
Installation/Troubleshooting Table of Contents Before Using ..............4 IMPORTANT SAFETY INSTRUCTIONS........4 1.1.1 FCC and Other Information ............... 5 Camera Feature Locations............. 7 1.2.1 Front View....................7 1.2.2 Bottom View ....................8 1.2.3 Rear View ....................8...
Installation/Troubleshooting Before Using IMPORTANT SAFETY INSTRUCTIONS When using this unit, basic safety precautions should always be followed to reduce the risk of fire, electric shock, or personal injury. Read and understand all instructions. Keep these instructions. Heed all warnings. Follow all instructions. After taking away the dust on the lens, wipe the lens with a cotton bud.
Wipe the unit with a soft cloth. Do not use benzine, thinner, or any abrasive powder. When you leave the unit unused for a long period of time, unplug the AC adaptor from the outlet. If you have any problems: Consult an authorized Panasonic Factory Service Center.
Page 6
Installation/Troubleshooting Caution • To comply with FCC RF exposure requirements in uncontrolled environment: • This equipment must be installed and operated in accordance with provided instructions and a minimum 20 cm (8inches) spacing must be provided between antenna and all person's body (excluding extremities of hands, wrist and feet) during wireless modes of operation.
Installation/Troubleshooting Camera Feature Locations 1.2.1 Front View Antenna Pan/tilt Part Do not apply pressure to the pan/tilt portion of the camera. Any forced movement can damage the internal mechanism. Indicator/Privacy Button Pyroelectric Infrared Sensor (see Getting Started) Privacy Button To temporarily deactivate the camera, press the privacy button. Once pressed, the button changes from green to red.
Used when installing the camera onto a wooden wall. Note If the ceiling is made of wood, the camera can be installed on the ceiling. See Panasonic Network Camera support website at http://panasonic.co.jp/pcc/ products/en/netwkcam/ for details.
Page 12
Symptom Send the unit to an authorized servicenter, prepaid and adequately insured. Do not send your unit to the Panasonic Consumer Electronics Company listed below or to executive or regional sales offices. These locations do not repair consumer products. Operating Instructions are subject to change without notice.