Installing the Avaya Ethernet Routing Switch
3. Slide the transceiver from the module slot.
4. If the transceiver does not slide easily from the module slot, use a gentle side-to-side rocking
motion while firmly pulling the transceiver from the slot.
5. Attach a dust cover over the fiber-optic bores and store the transceiver in a safe place until
you need it.
Important:
Discard transceivers in accordance with the proper laws and regulations.
RJ-45 connector pin assignments
The following section describes the connector pin assignments for the RJ-45 connectors.
Avaya Ethernet Routing Switch 4826GTS-PWR+ and 4850GTS-
PWR+
The following table describes the Power over Ethernet, and Power over Ethernet Plus RJ-45
connector pin assignments in the Avaya ERS 4826GTS-PWR+ and 4850GTS-PWR+.
Table 4: PWR PoE, and PWR+ RJ-45 connector pin assignments
Connector
Pin Number
1
2
3
4
5
6
7
8
Important:
The Avaya ERS 4800 PWR+ models use pins 1, 2, 3, and 6 for PoE Plus, and is compliant with
Type 2 (MDI-X) in IEEE802.3at.
Console port pin assignments
The following table describes the console port pin assignments.
August 2016
Signal
RX+/power–
RX–/power–
TX+/power+
Not applicable
Not applicable
TX–/power+
Not applicable
Not applicable
Installing Avaya ERS 4800 Series
Comments on this document? infodev@avaya.com
Description
Recieve Data+/power–
Receive Data–/power–
Transmit Data+/power+
Not applicable
Not applicable
Transmit Data–/power+
Not applicable
Not applicable
16