Using The Hole Puncher; Setting The Default Hole Punching Option - Xerox Phaser 5550 User Manual

Using the Hole Puncher

Depending on your region, the optional finisher is factory configured with either a 3-hole
punch or a 2- / 4-hole punch unit. To determine which option is installed on your printer, print
a Configuration Page from the control panel.
■
■
■
To select hole punching in a supported driver:
Operating System
Windows 2000 or later
Mac OS X (version 10.3
and higher) driver

Setting the Default Hole Punching Option

The default hole punching option is selected through the control panel or through
CentreWare IS.
Control Panel
To set the default hole punching option on the control panel:
1.
2.
3.
4.
CentreWare IS
1.
2.
3.
4.
5.
6.
7.
Downloaded From ManualsPrinter.com Manuals
When the hole punch option is turned on, sheets that are sent to the Stacker Upper Tray or
the Stacker Lower Tray are punched.
When the hole punch option is turned off, no paper is punched.
When the printer detects that the punch waste box is full, a warning appears on the control
panel, and printing continues without punching.
Steps
1.
2.
1.
2.
On the control panel, select
Select
Paper Handling Setup
Select Punch , and then press the OK button to toggle it on or off.
If you have a 2-hole and 4-hole punch, then set
Launch your web browser.
Enter your printer's IP address in the browser's Address field.
Click Properties.
In the left navigation tree, expand General and then click Printer Defaults.
Select On or Off in the Punch drop-down menu.
Select the desired number of holes in the Punch Holes drop-down menu.
Click the Save Changes button.
Select the Paper Output tab.
Select Hole Punch or the number of holes in the Hole Punch
drop-down list.
In the Print dialog box, select Finishing Options from the
drop-down list.
Select the number of holes under Hole Punching.
, and then press the OK button.
Printer Setup
, and then press the OK button.
Punch Holes
Phaser® 5550 Printer
4-54
Using the Hole Puncher
to or .
2 Holes 4 Holes