Dhcpv6 - Xerox Phaser 5550 User Manual

DHCPv6

DHCPv6 is used to acquire TCP/IP information.
The following DHCPv6 options are available in CentreWare IS:
■
■
■
■
To enable/disable automatic address assignment, use one of the following options:
■
■
Setting DHCPv6 Options with the Control Panel
To change DHCPv6 options using the control panel:
1.
2.
3.
4.
5.
6.
Setting DHCPv6 Options Using CentreWare IS
To change DHCPv6 options using CentreWare IS:
1.
2.
3.
4.
5.
6.
7.
Downloaded From ManualsPrinter.com Manuals
As directed by the router - DHCPv6 is performed according to values in a router
advertisement. This is the default setting.
Always, for all configuration options (stateful) - Stateful DHCPv6 is always attempted,
and router flags related to how to perform DHCP are ignored. Configuration options and
an IPv6 address will be accepted if DHCPv6 is successful.
Always, for all configuration options except address (stateless) - Stateless DHCPv6 is
always attempted, and router flags related to how to perform DHCP will be ignored.
Configuration options will be accepted if DHCPv6 is successful, but no IPv6 address will
be assigned.
Never - DHCPv6 is not used even if directed to do so by a router.
The printer's control panel
CentreWare IS
Select , and then press the OK button.
Printer Setup
Select
Connection Setup
Select , and then press the OK button.
Network Setup
Select , and then press the OK button.
TCP/IPv6 Setup
Select , and then press the OK button.
DHCPv6 Mode
Select the DHCPv6 option, and then press the OK button.
Launch your web browser.
Enter your printer's IP address in the browser's Address field.
Click Properties.
Select the Protocols folder on the left navigation panel, and then click TCP/IP.
Click the TCP/IP (v6) button.
Select/deselect the DHCPv6 options.
Click the Save Changes button at the bottom of the page.
, and then press the OK button.
Phaser® 5550 Printer
3-29
IPv6