6Rd - TP-Link TD-W8961N User Manual

TD-W8961N

Action: To filter wireless users by MAC Address, select Allow Association or Deny
Association the follow Wireless LAN station(s) association.

MAC Address: Enter the MAC Address you wish to filter in the field.

Note:
For most users, it is recommended to use the default Wireless LAN Performance settings. Any
changes made to these settings may adversely affect your wireless network. Under certain
circumstances, changes may benefit performance. Carefully consider and evaluate any changes
to these wireless settings.

4.2.4 6RD

IPv6 tunnel is a kind of transition mechanism to enable IPv6-only hosts to reach IPv4 services,
and to allow isolated IPv6 hosts and networks to reach each-other over IPv4-only infrastructure
before IPv6 completely supplants IPv4. It is a temporary solution for networks that do not support
native dual-stack, where both IPv6 and IPv4 run independently.
As a type of IPv6 tunnel, 6RD is used in the situation that your WAN connection is IPv4 while LAN
connection is IPv6. Go to Interface Setup→6RD.
 6RD Enable: The default setting is disabled. Select Enable when your WAN connection is
IPv4 while LAN connection is IPv6.
6rd IPv6 Prefix: Enter the prefix of the IPv6.

 IPv4 Mask Length: The length of the selected WAN connection's IPv4 mask.
 6RD Border Relay IPv4Addr: The IPv4 address of the border relay router of 6RD tunnel.
 Use PVC: Select the PVC from the drop-down list.
300Mbps Wireless N ADSL2+ Modem Router User Guide
37