TP-Link TD-W8961N User Manual page 27

TD-W8961N

Note:
Each IP address entered in the fields must be in the appropriate IP form, which is four IP octets
separated by a dot (x.x.x.x), such as 192.168.1.100. The modem router will not accept the IP
address if it is not in this format.
3) PPPoA/PPPoE
Select this option if your ISP requires you to use a PPPoE connection. This option is typically
used for DSL services. Select Dynamic PPPoE to obtain an IP address automatically for your
PPPoE connection. Select Static PPPoE to use a static IP address for your PPPoE connection.
Please enter the information accordingly.

Servicename: Enter a name to mark current connection, or you can leave it blank.

Username: Enter your username for your PPPoA/PPPoE connection.

Password: Enter your password for your PPPoA/PPPoE connection.

Encapsulation: For both PPPoA and PPPoE connection, you need to specify the type
of Multiplexing, either LLC or VC Mux.

Bridge Interface: Activate the option, and the modem router can also work in Bridge
mode.

Connection: For PPPoA/PPPoE connection, you can select Always on or Connect
on-Demand or Connect Manually. Connect on demand is dependent on the traffic. If
there is no traffic (or Idle) for a pre-specified period of time, the connection will tear down
300Mbps Wireless N ADSL2+ Modem Router User Guide
21