Setting The Tam Interface Mode; Operation Of Tam Interface Mode - Panasonic DX-800 Network Fax Manual

Receiving Documents via Telephone Line
TAM (Telephone Answering Machine) Interface Mode

Setting the TAM Interface Mode

1

Operation of TAM Interface Mode

If it is a Fax call,
1
2
If it is a Voice call,
1
2
Hello, this is Smith. Sorry I am unable to take your call. Please leave your message after the beep or if you are
calling to send a fax, press the asterisk button twice on your touch tone phone now and start your machine. Thank
you for calling.
Enables your Fax machine to switch to the Fax Mode when receiving from units that do not send fax signal (short
beep) and prevents your TAM from recording blank (long silence) incoming message.
To activate this feature,
1. Change Fax Parameter No. 20 (SILENT DET.) to 2 : Valid. (See page 80)
2. Set the time length of the OGM recorded in your TAM with the Fax Parameter No. 19 (OGM LENGTH). (See
page 80)
[We recommend to set the time length 5 or 6 seconds longer than the actual time length of the OGM.]
132
Change Fax Parameter No. 17 (RECEIVE MODE) to 4: TAM/FAX.
(See page 80)
When your TAM and Fax receives an incoming call, the
TAM always answers the call first and then the TAM plays
the OGM (Outgoing Message) recorded in your TAM to
the calling station. During the time the TAM is answering
the call, your fax machine will be monitoring the line to
distinguish whether it is a voice or fax call.
Your machine will switch the line to the fax and then begin
to receive the documents immediately from the calling
station.
When your TAM and Fax receives an incoming call, the
TAM always answers the call first and then the TAM plays
the OGM (Outgoing Message) recorded in your TAM to
the calling station. During the time the TAM is answering
the call, your fax machine will be monitoring the line to
distinguish whether it is a voice or fax call.
Your TAM continues to record a message (ICM) after
playing the OGM.
Sample of OGM
Silent Detection Mode