Table of Contents
Advertisement
Programming or Retrieving Parameters via Email
To Input the Internet Parameters for the First Time
Create a script in the message body of a plain text email and send it to the DX-2000's email address. The
"Subject" line of the email must be as follows:
#set parameters(password)#: where the password is the Remote Password programmed in the DX-2000's
Important:
The script sample to input the Internet Parameters is shown below.
Continued on the next page...
User Parameters.
For security, always input a Remote Password in the User
Parameters. [If it was not programmed, signify with "()" (i.e. #set parameters()#)
and assign one now].
Do not use the above command if these fields already contain data, the existing
information will be deleted and overwritten. Retrieve and backup the existing
data onto your PC first by following the procedures for Retrieving and Editing the
Internet Parameters on pages 48 to 52.
(1)
(3)
(a)
(b)
(c)
(d)
(2)
(4)
2
47
Advertisement
Table of Contents
