Installation Into The Back Of A Panel - Siemens MAG 1100 Handbook


SITRANS F M MAGFLO
6.2.8
Installation into the back
of a panel
48
6. Installation of signal converter
1. Mount the SENSORPROM
The SENSORPROM ® unit is supplied with the sensor in the terminal box.
2. Mount the connection board into the back of the enclosure.
3. Connect the cables as shown under "Electrical connection", chapter 7.
4. Mount the enclosure into the back of a panel with four screws.
5. Insert the signal converter.
DKFD.PS.027.W3.02
® memory unit on the connection board as shown.