Motor Control; Motor & Periphery; Drive Functions - Siemens Sinamics G120 Operating Instructions Manual

Motor control

This option allows the user to view, and if required, change the
method by which the Inverter controls the attached motor. It
presents the following control functions:
• V/f control
• Sensorless Vector control
The Inverter will not allow the control mode to be changed
while the motor is running. The motor and therefore the
system, must be stopped to allow the control mode to be
changed.
Motor & periphery
This option allows the following motor functions and options to
be viewed, configured and modified:
• Motor data
• Motor temperature
• Motor encoder
• Motor holding brake
It is important that if any parameters concerning the above
mentioned functions are to be modified, that the Inverter/motor
system is in a safe state prior to the parameter changes. This
is essential if any changes are being made to the Motor
holding brake - all loads that may be affected by the change
must be secured to avoid potentially dangerous situations.

Drive functions

This option allows the user direct access to the parameters
regarding the following drive functions:
• Shutdown functions
• Brake control
• Vdc controller
• Automatic restart
• Flying restart
• Safety Integrated
It is important that if any parameters concerning the above
mentioned functions are to be modified, that the Inverter/motor
system is in a safe state prior to the parameter changes.
Intelligent Operator Panel (IOP)
Operating Instructions, 03/2013, FW V1.4, A5E00110011A4 AB
Menu
6.3 Parameters
65