Siemens Sinamics G120 Operating Instructions Manual page 32

Wizards
4.1 Example wizard
11. Input the correct Motor Speed from the motor rating
12. Select to run or disable Motor Data Identification
13. Select either zero pulse on no zero pulse for the
14. Enter the correct pulses per revolution for the encoder.
15. Select the command source for the controlling
32
plate.
This value is given in RPM.
function.
This function, if active, will not start until the first run
command is given to the Inverter.
attached encoder.
If no encoder is fitted to the motor, the option will not be
displayed.
This information is normally printed on the casing of the
encoder.
commands for the Inverter/motor system.
Operating Instructions, 03/2013, FW V1.4, A5E00110011A4 AB
Intelligent Operator Panel (IOP)