Torque Control - ABB PST30 Installation And Commissioning Manual

Chapter 7
Settings and configuration
Settings
Functional Settings
Figure 27: Torque control group
94

7:2.4.2 Torque control

To set parameters related to torque control, enter the Torque
control group.
Start/Stop
Start mode
Torque control
Select which type of ramp that shall be used during start. The
possible options are:
Protections
• Volt
Warnings
• Torque
Press Store to save the selected start mode.
Faults
Stop mode
Inputs
Select which type of ramp that shall be used during stop. The
possible options are:
Outputs
• Volt
Analog Output
• Torque
Fieldbus
Press Store to save the selected stop mode.
Seq Start
Tune torque control (Tune T-Ctrl)
With this parameter it is possible to fine-tune the behavior of
the torque ramps. This parameter should usually be set to its
default value 100%.
Press Store to save the selected level.
Torque limit
Select the torque limit of the softstarter.
Press Store to save the selected torque limit level.
1SFC132003M0201