Faults - ABB PST30 Installation And Commissioning Manual

Chapter 7
Settings and configuration
Settings
Functional Settings
Figure 30: Faults group
102

7:2.4.5 Faults

Start/Stop
Torque control
Caution!
The motor may start unexpectedly if there is a start signal
Protections
present when the softstarter has tripped for a fault and a
reset is performed. This reset can be either manual (Stop-
Warnings
M) or automatic (Stop-A).
Faults Phase loss fault, type of operation (Ph Loss
Op)
Inputs
Select what operation shall be asserted if a phase loss fault
occurs:
Outputs
Stop–M
Analog Output
Stop–A
Fieldbus
Press Store to save the selected operation.
Seq Start
Fieldbus fault, type of operation (FB Fault Op)
Select what operation shall be asserted if a fieldbus
communication fault occurs:
Stop–M
Stop–A
Press Store to save the selected operation.
Frequency fault, type of operation (Freq F Op)
Select what operation shall be asserted if the frequency fault
occurs (out of range):
Stop–M
Stop–A
Press Store to save the selected operation.
Heat sink over-temperature fault, type of
operation (HS Temp Op)
Select what operation shall be asserted if an over-
temperature occurs:
Stop–M
The motor will stop and a manual reset is
required.
The motor will stop and an automatic reset is
performed.
The motor will stop and a manual reset is
required.
The motor will stop and an automatic reset is
performed.
The motor will stop and a manual reset is
required.
The motor will stop and an automatic reset is
performed.
The motor will stop and a manual reset is
required.
1SFC132003M0201