Changed Settings; Reset All Settings - ABB PST30 Installation And Commissioning Manual

Top Level
Settings
Figure 39: Changed Settings menu
Top Level
Settings
Figure 40: Reset all Settings menu
1SFC132003M0201

7:2.7.1 Changed Settings

Application
Settings
Basic
Settings
Functional
Settings
Presentation
Settings
Service
Settings
All
Settings
Changed
Settings
Reset all
Settings
Operation
Mode

7:2.7.2 Reset all Settings

Application
Settings
Basic
Settings
Functional
Settings
Presentation
Settings
Service
Settings
All
Settings
Changed
Settings
Reset all
Settings
Operation
Mode
The Changed settings menu consists of the parameters that
have been changed in contrast to the factory default setting.
If no parameters have been changed, the LCD will display No
Changed Settings.
To reset all the changed parameters back to factory default
setting, enter this menu.
Confirmation of reset will be displayed as Done on the LCD.
The supply voltage should also be disconnected and
reconnected.
The real time clock, the hour run meter, the number of starts
and the presentation language will not be affected by the
reset.
Caution!
The motor may start unexpectedly if there is a start signal
present when doing any of the actions listed below.
• Switching from one type of control to another (fieldbus
control / hardwire control)
• Re-programming of the programmable inputs
• Reset all Settings (programmable input set to Enable)
Chapter 7
Settings and configuration
117