Installing The Chassis - Avaya P550R Installation Manual

Chapter 1

Installing the Chassis

Rack Mounting
the System
WARNING
WARNING
1-4
The system can be installed by:
Rack Mounting the System
Installing the System on a Table Top
To install the switch in a rack:
To avoid physical injury, three people are required to safely install
the switch in a rack: two to lift the system into place, and a third to
screw the system to the rack using a Phillips-head screwdriver. A
fully-loaded P550R/P580 switch weighs 60 kg (130 lbs). A fully
loaded P880/P882 switch weighs 80 kg (182 lbs).
Do not use the handles on the power supplies or fan assembly to lift
the system.
1. Install the two rack mount flanges from the rack installation
kit to the sides of the switch
* Note: The screws and nuts needed to attach the rack mounting
flange to the rack are not supplied. It is recommended
you use at least four #10 pan head screws to attach the
bracket to the rack.
Compare the holes in the rack mount flange against the
holes in your rack to ensure they properly line up.
Figure 1-2. Rack Mounting the Switch
Installation Guide for the Avaya P550R, P580, P880, and P882 Multiservice Switches v5.3.1
(Figure 1-2).
Rack Mounting
Flange
Switch Chassis