Changing From Fabric 2 Mode To Fabric 1 Mode - Avaya P550R Installation Manual

Changing from Fabric 2 Mode to Fabric 1 Mode

Installation Guide for the Avaya P550R, P580, P880, and P882 Multiservice Switches v5.3.1
4. Type the following command to change your switch from
Cajun mode 1 to Cajun mode 2:
Cajun (configure)# set Fabric_mode 2
There will be a prompt asking you to reboot the P580/P880/P882
Multiservice switch. The switch will be in Fabric 2 mode after it
reboots.
* Note: With redundant supervisor modules, each
supervisor module must be changed
individually. Supervisor modules must run in
the same fabric mode to function properly.
To change your Avaya P580/P882 Multiservice switch from Fabric 2
mode to Fabric 1 mode:
1. Telnet to the switch.
2. Type enable (en) at the Cajun switch prompt to enter enable
mode. The enable mode prompt displays:
Cajun #
3. Type configure to enter configure mode. The configure
prompt displays:
Cajun (configure)#
4. Type the following command to change your switch from
Fabric 2 mode to Fabric 1 mode:
Cajun (configure)# set Fabric_mode 2
There will be a prompt asking you to reboot the Avaya P580/P882
Multiservice switch. The switch will be in Fabric 1 mode after it
reboots.
* Note: With redundant supervisor modules, each
supervisor module must be changed
individually. Supervisor modules must run in
the same fabric mode to function properly.
Initial Configuration
2-11