Changing Fabric Modes; Changing From Fabric 1 Mode To Fabric 2 Mode - Avaya P550R Installation Manual

Chapter 2
User Level
User
(READ_ONLY)
Manager
(READ_WRITE)
Administrator
(ADMINISTRATOR)

Changing Fabric Modes

Changing from Fabric 1 Mode to Fabric 2 Mode

2-10
7. From the Access Type pull-down menu, select an access
type (Table
Table 2-3. Access Type Pull Down Menus Options
Can
View switch configuration
settings and statistics.
View and set switch
configuration settings, and
view statistics.
View and set all switch
parameters.
8. Click APPLY to save your changes, or CANCEL to restore
previous settings.
This section explains how to change an Avaya P580/P882 switch
from Fabric 1 mode to Fabric 2 mode and vice-versa.
* Note: You can use the following procedures to change Fabric
modes only on a P580/P882 Switch with an 80-series
supervisor module.
To change your Avaya P580/P882 Multiservice switch from Fabric 1
mode to Fabric 2 mode:
1. Telnet to the switch.
2. Type enable (en) at the Cajun switch prompt to enter enable
mode. The enable mode prompt displays:
Cajun #
3. Type configure to enter configure mode. The configure
prompt displays:
Cajun (configure)#
Installation Guide for the Avaya P550R, P580, P880, and P882 Multiservice Switches v5.3.1
2-3).
Cannot
View user accounts and
community strings. Change
switch configurations.
View user accounts and
community strings.
N/A