TG7100-7102-7103NE(e-da).book Page 24 Wednesday, April 19, 2006 1:09 PM
Useful Information
Error messages
Error message
Hukommelse fuld
Man skal abonnere på vis
nummer
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the AC adaptor and
turn off the handset, then reconnect the AC adaptor and turn on the handset.
Telephone
Problem
w is flashing.
The handset display is blank.
The handset will not turn on.
I have changed the display language to
a language I cannot read.
24
Cause & solution
L The handset's phonebook memory is full. Erase
unnecessary entries (side 14).
L You must subscribe to Caller ID service. Once you
receive caller information after subscribing to Caller ID
service, this message will not be displayed.
Cause & solution
L The handset is not registered to the base unit. Register it
(side 20).
L The handset is too far from the base unit. Move closer.
L The AC adaptor is not connected. Check the
connections.
L You are using the handset or base unit in an area with
high electrical interference. Place the handset and base
unit away from interference sources, such as antennas
and mobile phones.
L The handset is not turned on. Turn the power on (side
10).
L Make sure that the batteries are installed correctly (side
9).
L Fully charge the batteries (side 9).
L Clean the charge contacts and charge again (side 9).
L Change the display language (side 10).