Programming; Programmable Settings - Panasonic KX-TG5961AL Operating Instructions Manual

Programming

Programmable settings

You can customise the unit by programming the following features using the handset. To
access the features, there are 2 methods:
– scrolling through the display menus (page 40)
– using the direct commands (page 44)
L Mainly the direct command method is used in these operating instructions.
L To change the base unit ringer volume and tone, see page 26.
Programming by scrolling through the display menus
1
{MENU} (middle soft key)
2
Press {^}, {V}, {<}, or {>} to select the desired menu. i {SELECT}
L If there are sub-menu(s), press {^} or {V} to select the desired item. i {SELECT}
Example: To access the handset ringer volume setting
Press {^}, {V}, {<}, or {>} to select (. i {SELECT}
Then press {^} or {V} to select "Ringer volume". i {SELECT}
3
Press {^} or {V} to select the desired setting.
L This step may vary depending on the feature being programmed.
4
{SAVE} i {OFF}
Monochrome display models: KX-TG5961AL/KX-TGA590AL
L When you find "*1" or "*2" in the following table, refer to the note below.
*1 If you programme these settings using one of the handsets, you do not need to
programme the same item using another handset.
*2 Use either the handset or base unit to turn the dial lock on/off for all units at once (page
28).
Main menu
Voice Mail
40
Sub-menu 1
Store VM access#
Message alert
Sub-menu 2
*1
–
–
Page
52
53