Troubleshooting - Panasonic KX-TG2344 Quick Setup Manual

Troubleshooting

If the handset display shows error messages, see "If the Following Appear on
Your Display..." (p. 64–65) for the Cause & Remedy.
Telephone System
Problem
"No link to base. Move
closer to base, try
again." is displayed and an
alarm tone sounds.
Static, sound cuts in/out,
fades. Interference from
other electrical units.
The handset does not ring.
The handset display is blank.
You cannot program any
function items.
While programming or
searching, the handset starts
to ring and the program/
search stops.
You cannot make an
intercom/outside call.
You cannot redial.
Cause & Remedy
• You are too far from the base unit. Walk closer
to the base unit.
• Confirm the base unit's AC adaptor is plugged
in.
• Raise the base unit antenna.
• If the above remedies do not solve the
problem, the handset may have lost
communication with the base unit. Register
the handset again (p. 48).
• Move the handset and base unit away from
other electrical appliances (p. 3).
• Walk closer to the base unit.
• Raise the base unit antenna.
• The ringer volume is turned off. Set to high,
medium, or low (p. 17).
• If only the handset display is blank, fully
charge the battery (p. 10).
• Programming is not possible while the handset
and/or base unit is being used.
• Do not pause for over 60 seconds while
programming.
• Walk closer to the base unit.
• While another user is listening to messages or
the Answering System is handling a call, you
cannot program. Try again later.
• A call is coming in. To answer the call, press
[C] or [s]. Start again from the beginning
after hanging up.
• Your handset is in remote operation mode
(p. 52). Exit by pressing [OFF].
• The handset you called is too far from the
base unit.
• If the handset or base unit is in use, you may
not be able to make a call. Try again later.
• If the last number dialed was more than
48 digits long, the number will not be redialed
correctly.