Caller's Recording Time - Panasonic KX-TG2344 Quick Setup Manual

Preparing the Answering System
To review the greeting
Press [GREETING CHECK].
To erase the greeting
Press [GREETING CHECK], then press [ERASE] while the recorded
message is being played.
• The unit will answer calls with a pre-recorded greeting (see below).
Pre-recorded greeting
If you do not record a greeting (p. 19), one of two greetings will be played when a
call is received, depending on the caller's recording time (see below).
To review the pre-recorded greeting, press [GREETING CHECK].
• A pre-recorded greeting will be played as follows:
■ When the recording time is set to "1 minute", "2 minutes" or "3 minutes":
"Hello, we are not available now. Please leave your name and phone number after the
beep. We will return your call."
• If recording time runs out, the unit will automatically switch to the "Greeting only"
mode (see below), and no new messages will be recorded.
■ When the recording time is set to "Greeting only":
"Hello, we are not available now. Please call again. Thank you for your call."
Flash Memory Message Backup (Message storage)
Messages stored in memory will not be affected by power failures. All messages
are saved until you erase them.

Caller's Recording Time

You can select "1 minute", "2 minutes", "3 minutes" or "Greeting only" for the caller's
recording time. The factory preset is "3 minutes".
1
Press [MENU].
2
Scroll to "Initial setting" by pressing [d]
or [B], then press Select.
3
Press Select at "Set answering".
4
Scroll to "Recording time" by pressing [d]
or [B], then press Select.
Handset
Initial setting
K
Back
Set answering
K
Back
Recording time
K
Back
L
Select
dB
L
Select
dB
L
Select
dB