Condenser Cleaning - True GDM Series Technical & Service Manual

GENERAL MAINTENANCE

CONDENSER CLEANING

Step 4
Step 6
REQUIRED TOOLS
• Phillips Screwdriver
• Stiff Bristle Brush
• Adjustable Wrench
____________ STEP 1 ____________
Disconnect power to unit.
____________ STEP 2 ____________
Take off lower grill assembly by removing
four (4) corner screws.
____________ STEP 3 ____________
Remove bolts anchoring compressor
assembly to frame rails and carefully slide
out. (tube connections are flexible)
____________ STEP 4 ____________
Clean off accumulated dirt from condensing
coil with a stiff bristle brush.
____________ STEP 5 ____________
Lift cardboard cover above fan at plastic
plugs and carefully clean condenser coil
and fan blades.
____________ STEP 6 ____________
After brushing condenser coil vacuum dirt
from coil, and interior floor.
18
____________ STEP 7 ____________
Replace cardboard cover. Carefully slide
compressor assembly back into position
and replace bolts. When reinstalling
condensing unit becareful not to crimp
or damage the tubing between the con-
densing unit and the cabinet.
____________ STEP 8 ____________
Reinstall louver assembly onto unit with
appropriate fastener and clips. Tighten all
screws.
____________ STEP 9 ____________
Connect unit to power and check to see if
compressor is running.