Overshelf Option - Tssu, Twt, Tuc - True GDM Series Technical & Service Manual

Hide thumbs Also See for GDM Series:
Table of Contents

Advertisement

INSTALLATION INSTRUCTION

OVERSHELF OPTION - TSSU, TWT, TUC

Congratulations on your purchase of an accessory that has been designed to efficiently assist your food
preparation. The following instruction has been written to assist you in your overshelf installation.
KIT CONTENTS
• Shelf, 1 ea.
• Shelf supports, 2 ea. (60" models
offer 3 ea.)
• 1/4-20x1" Hex Head Bolt, 4 ea.
• 1/4-20x1-1/2" Hex Head Bolt, 4 ea.
(60" models offer 6 ea.)
• 1/4" Flat Washer, 4 ea. (60" models
offer 6 ea.)
REQUIRED TOOLS
• 7/16 Wrench
INSTALLATION
___________ STEP 1 ___________
Place one flat washer on each of the
1/4-20x 1-1/2" hex head bolts and
insert one of these assemblies into each
mounting hole, located on the longer
section of the square shelf support.
___________ STEP 2 ___________
Hold the shelf support next to the
threaded holes that are located along
the edge on the back of the cabinet,
(60" models have a third shelf support
that is located near the center of the
cabinet back).
___________ STEP 3 ___________
Carefully thread the 1/4-20 x 1-1/2"
bolts into these threaded holes until the
supports make contact with the cabinet
and the bolts are hand tight.
___________ STEP 4 ___________
Repeat steps 2 and 3 to install the sec-
ond shelf support, (for 60" models,
repeat steps 2 and 3 for the third sup-
port).
___________ STEP 5 ___________
Hold the shelf up between the two
mounted shelf supports and thread one
1/4-20x1" hex head bolt into each of
the two threaded holes that are located
on the inside surface of each shelf sup-
port, (for the 48" and 60" models, have
someone help hold the shelf in posi-
tion). Thread each bolt until the shelf
is drawn against the shelf support and
the bolt is hand tight.
81
Figure 1.
___________ STEP 6 ___________
Adjust the shelf assembly so that the
shelf supports are vertical and the shelf
is flat
___________ STEP 7 ___________
Firmly tighten each bolt using the
7/16 wrench.
CAUTION
Do not place more than 100 lbs.
of weight upon the overshelf, and
never stand on the overshelf.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Gdt series

Table of Contents