Ratchet Lock & Plastic Door Stop - Slide Door - True GDM Series Technical & Service Manual

INSTALLATION INSTRUCTION
RATCHET LOCK & PLASTIC DOOR STOP - SLIDE DOOR ...Continued
Plastic Door Stop Installation Instruction
(Unnecessary if factory installed)
REQUIRED TOOLS
• Drill With 1/8" Bit
• Phillips Head Screwdriver
__________ STEP 1 __________
Remove left side door by lifting up
and out of bottom track.
__________ STEP 2 __________
Position the plastic door stop cen-
tered in the front door channel and
mark it. Center within the confines
of the door that was removed.
__________ STEP 3 __________
Peel backing from double-sided
tape and position on previously
marked spot.
__________ STEP 4 __________
Drill 1/8" holes using the pre-
drilled holes of the plastic door stop
as a template.
__________ STEP 5 __________
Install phillips counter-sunk screws
provided. (see figure 3.)
__________ STEP 6 __________
Replace left side door and check
slide operation. If door stop
impedes closing of left hand door,
remove door, detach plastic door
stop and remove one layer or piece
of the door stop and reinstall.
NOTE:
Length of door stop and
number of screws determined
by cooler model
78
Figure 3