Td-Series And Glass Chillers - True GDM Series Technical & Service Manual

TD-SERIES AND GLASS CHILLERS

Replacement of Lid Rails, Lid
Rail Trunions and Lid Gaskets
Tools Required
- 1/4" Nut Driver
- Pop Rivet Gun
- Drill motor
- Phillips Head Screwdriver
- Utility Knife
- Duct Tape
- #29 Drill Bit
Note:
For easier installation of new
lid rails and lid trunions,
it's best to remove the top
from the cabinet.
Note:
When changing out lid rails or
lid trunions on a T-50-GC, the
trunion has a mullion heater
looped through it.
_________ STEP 1 _________
Disconnect electrical power to
cabinet.
_________ STEP 2 _________
Remove top from cabinet (See
Top Removal instructions for TD
& T-GC on page 30).
_________ STEP 3 _________
Once top is removed, turn top
upside down and remove galva-
TD-Series and Glass Chillers
nized air deflector.
expose the hidden screws hold-
ing trunions and lid rails to top
and any tape on the back side of
the lid rails. This will need to be
cut or removed.
_________ STEP 4 _________
Remove old lid rails and lid
trunions. Note how the lid rails
have a slot in the top edge which
slides into the inside edge of the
stainless steel top. Once you
have new lid rails in place, you
will need to re-tape to secure
them until top is re-installed on
cabinet. Install new lid trunions
and any lid gaskets that may
need replacing.
_________ STEP 5 _________
Re-install air deflector to top.
_________ STEP 6 _________
Re-install top to cabinet (See Top
Removal instructions for proce-
dure).
_________ STEP 7 _________
Once top has been installed, you
will need to install the new lid
rail covers. These will insert into
the lid rails (sides only) and
trunions. You will need to use
your drill motor and a #29 drill
bit, drill 2 holes about 12" apart
in each lid rail to install the 1/8"
42
This will aluminum rivets (2 each) in each
lid rail cover.
Be sure to use only aluminum
rivets as steel may rust.
Note: