Planet WNAP-6315 User Manual page 62

The page includes the following fields:
Object
Fragment Threshold
RTS Threshold
Beacon Interval
Preamble Type
Antenna
IAPP
Protection
Aggregation
Short GI
WLAN Partition
STBC
LDPC
20/40MHz Coexist
You can specify the maximum size of packet during the fragmentation
of data to be transmitted. If you set this value too low, it will result in
bad performance.
Default is "2346".
When the packet size is smaller than the RTS threshold, the access
point will not use the RTS/CTS mechanism to send this packet.
Default is "2347".
The interval of time that this access point broadcasts a beacon.
Beacon is used to synchronize the wireless network. Default is "100".
Preamble type defines the length of CRC block in the frames during
the wireless communication. "Short Preamble" is suitable for high
traffic wireless network. "Long Preamble" can provide more reliable
communication. Default is "Long Preamble".
Choose "External" to switch the antenna to external antenna.
※ For External Antenna Mode, user MUST physically attach antenna
before powering on. Then, configure the Antenna Switch (Wireless
Advanced page) from "Internal" to "External".
Default is "Internal".
IAPP (Inter-Access Point Protocol) enabled is recommended as it
describes an optional extension to IEEE 802.11 that provides wireless
access-point communications among multivendor systems.
Default is "Enabled".
Enables a backward compatible protection mechanism for 802.11b
clients. When the protection mode is enabled can slow the throughput
of the 802.11g/n clients by as much as 50%.
Default is "Disabled".
It is a function where the values of multiple rows are grouped together.
Default is "Enabled"
It is used to set the time that the receiver waits for RF reflections to
settle out before sampling data.
Default is "Enabled"
This feature also called "WLAN isolation" or "Block Relay". If this is
enabled, wireless clients cannot exchange data through the
WNAP-6315.
Default is "Disabled".
Activate Space Time Blocking Code (STBC) which does not need
channel statement information (CSI).
Default Setting: "Enabled"
Low-density Parity-check Code is wireless data transmit algorithm.
Default Setting: "Enabled"
Configure 20/40MHz coexisting scheme.
If you set up as "Enabled", "20MHz" and "40MHz" will coexist.
-53-
User Manual of WNAP-6315
Description