Installing The Ap - Planet WNAP-6315 User Manual

3.3 Installing the AP

Please install the AP according to the following Steps. Don't forget to pull out the power plug and keep your
hands dry.
Step 1. Push the latch on the bottom of the WNAP-6315 to remove the sliding cover.
Step 2. Plug the RJ45 Ethernet cable into the PoE LAN Port of the WNAP-6315. Then, slide back the cover of
the WNAP-6315 to finish the installation.
Step 3. Plug the power cord into the DC port and plug the other end of the RJ45 cable into the POE port of the
PoE injector (See Step 2).
Figure 3-1 Connect the Antenna
Figure 3-2 Connect the Ethernet cable
Figure 3-3 Connect the PoE injector
-14-
User Manual of WNAP-6315