Planet WNAP-6315 User Manual page 20

H/W Interface Definition
Interface
RP-SMA Connector
LAN (Passive PoE)
WAN
Reset
Function
You can use the RP-SMA connector to connect with the 2.4GHz outdoor
antenna.
※ For External Antenna Mode, you MUST physically attach antenna before
powering on. Then, configure the Antenna Switch (Wireless Advanced page)
from "Internal" to "External" via Web UI.
10/100Mbps RJ45 port, auto MDI/ MDI-X & passive PoE supported.
Connect LAN port to the PoE injector to power on the device.
PIN assignment:
 Pin 4 VDC+
 Pin 5 Reset
 Pin 7, 8 VDC-
10/100Mbps RJ45 port, auto MDI/ MDI-X.
Connect this port to the xDSL modem in gateway mode.
Connect this port to the network equipment in bridge mode.
Push continually the reset button on the PoE injector about 10 seconds to
reset the configuration parameters to factory defaults.
※ If you have connected with the thunder protector like PLANET
ELA-100, please DO NOT press the reset button on the PoE injector to
prevent the ELA-100 from being damaged. Remove the thunder
protector before pushing the reset button.
Table 2-2 The PoE Injector Indication
User Manual of WNAP-6315
-11-