Planet WNAP-6315 User Manual page 41

Host Name
MTU Size
Attain DNS
Automatically
Set DNS Manually
Clone MAC
Address
Enable uPNP
Enable IGMP Proxy
Enable Ping Access
on WAN
Enable Web Server
Access on WAN
Enable IPsec pass
through on VPN
connection
Enable PPTP pass
through on VPN
connection
Enable L2TP pass
through on VPN
connection
Enable IPv6 pass
through on VPN
connection
Enter the Subnet Mask.
Server IP Address
Enter the L2TP Server IP address provided by your ISP.
User Name
Enter your L2TP user name.
Password
Enter your L2TP password.
This option specifies the Host Name of the Wireless AP.
The normal MTU (Maximum Transmission Unit) value for most Ethernet networks is
1492 Bytes. It is not recommended that you change the default MTU Size unless
required by your ISP.
Select "Attain DNS Automatically", the DNS servers will be assigned dynamically
from your ISP.
If your ISP gives you one or two DNS addresses, select Set DNS Manually and enter
the primary and secondary addresses into the correct fields.
You can input a MAC address here for using clone function.
Check to disable/enable uPNP function (default = disabled)
Check to disable/enable IGMP function (default = enabled)
Check to enable the Ping Access on WAN function (default = disabled)
Check to enable the Web Server Access on WAN function (default = disabled)
Check to enable the IPsec pass through on VPN connection function (default =
enabled)
Check to enable the PPTP pass through on VPN connection function (default =
enabled)
Check to enable the L2TP pass through on VPN connection function (default =
enabled)
Check to enable the IPv6 pass through on VPN connection function (default =
disabled)
User Manual of WNAP-6315
-32-