Point Of Interest - Mercedes-Benz COMAND Operator's Manual

Navigation
184
u The system shows a numbered list of
districts in the display if the selected
city has more than one district.
t Please select a line number.
s Line number 1 ...
t Line number 1 accepted.
The district is stored for route guidance.
"Enter Street"
You can use the "Enter Street" command to
enter the name of any street in the selected
city.
i If only a few streets are stored for a
selected town, they will be displayed for
selection immediately after you give the
"Enter Street" command.
Example of dialog:
s Enter Street
t Please say the name of the street
s Mabel's Street
u The system shows a numbered list of
street names on the display
t Please select a line number.
s Number three
t Number three accepted
The street name is stored for route guidance.
"Correction"
If you have entered or spelled a city or street,
you can use the "Correction" command to
enter the city or street again or spell it from
the beginning.
"House Number"
You can use the "House number" command
to specify the house number for the selected
street in individual digits.
Example of dialog:
s House number
t Please say the house number in single
digits
s Three four
t Three four
s Okay
The house number is stored for route
guidance.
"Point of interest" (POI)
You can use the "Point of interest" command
to select specific destinations (filling stations,
airports, stations, etc.).
Example of dialog:
s Point of interest
u The system shows the following list in
the display:
1. Current position
2. Other town
t Please select a line number.
s Line number 1 ...
t Line number 1 accepted.
u The system shows a numbered list of
POI categories
t Please select a line number or say the
category name
s Line number 5 ...
u The system shows a numbered list
with destinations from the selected
category
t Please select a line number.
s Line number 1 ...
t Line number 1 accepted.
The specific destination which has the
number one is stored for route guidance.
i Depending on the selected area, other
lists may be shown.
You can only select points of interest in the
state or province the navigation system is set
for.
Selecting next point of interest
You can use the following commands to
select nearby points of interest.