Mercedes-Benz COMAND Operator's Manual page 160

General Information
158
Setting the Volume (wired headset)
C
Skipping tracks forward/backward
D
Selecting a title directly
E
Leaving a menu
F
Selecting the Active Display Screen for
the Remote Control
With the remote control you can select which
of the two display screens is responsive to the
remote control.
X
Selecting the left/right display screen:
Rotate the wheel = until L or R appears in
the small window.
Switching On/Off the Display Screen
i If the ignition key is in position 0 or 1 (Y
vehicle operating guide) or the key is not
inserted, the display screens are switched
off automatically after 30 minutes. Before
switching off a corresponding message
appears.
You can switch on the screen(s) again but
be aware it will continue to discharge the
vehicle battery.
X
Point the remote control to the active
screen and press the button On/Off : on
the remote control.
The display screen is switched on or off.
i Switching on with the remote control is
only possible if the ignition is on.
Muting the Audio Playback (Only Wired
Headset)
X
Press the button B on the remote control.
Depending on the previous state the sound
is switched on or off.
Selecting a Menu Item and Confirming the
Selection
X
Selecting the menu item: Press the arrow
buttons ? on the remote control.
X
Confirming the selection: Press the OK
button A.
CD/DVD Drive and Aux Connectors
The CD/DVD drive is located in central
position behind the front seats.
CD/DVD slot
:
Aux, right (R) connector for audio signal
;
Aux, left (L) connector for audio signal
=
Aux, connector for video signal (V)
?
CD/DVD eject button
A
The Aux connectors shown here represent
the source Disk Drive Aux. The same
connectors are available at the display
screens. These represent the Aux source
Display Aux (
Y page 172).