Remote Control - BMW K1600GTL Rider's Manual

Switch on the ignition.
Press and hold down buttons 1
and 2 until LED 3 stops flash-
ing.
LED 3 flashes for about ten
seconds.
Release buttons 1 and 2.
LED 3 lights up.
Press button 1 or button 2.
LED 3 goes out.
Replacing battery of

remote control

If you press a button on the re-
mote control and the LED does
not show or lights up only briefly:
Replace the battery of the re-
mote control.
Open lid of battery compart-
ment 1.
Dispose of the old battery in
accordance with all applicable
laws and regulations; do not
attempt to dispose of batteries
as domestic waste.
Irreparable damage can be
caused to the device if the
wrong batteries are used or if
polarity is reversed.
Use a battery compliant with
the manufacturer's specifica-
tions. When inserting the bat-
tery, always make sure polarity is
correct.
Insert the new battery with the
positive terminal up.
Battery type and rated
battery voltage
for remote control
CR 1632 lithium
3 V
The LED on the remote control
lights up; the remote control
has to be synchronised.
4
81
z