Lighting - BMW K1600GTL Rider's Manual

Then connect one end of the
black jump lead to the negative
terminal of the donor battery,
and the other end to the neg-
ative terminal of the discharged
battery.
Start the engine of the vehicle
with the discharged battery
in the usual way; if the en-
gine does not start, wait a few
minutes before repeating the
attempt in order to protect the
starter motor and the donor
battery.
Allow both engines to idle for a
few minutes before disconnect-
ing the jump leads.
Disconnect the jump lead from
the negative terminals first,
then disconnect the second
lead from the positive termin-
als.
Installing seat ( 119).

Lighting

Replacing bulb for high-
beam headlight
The description below
steps you through the
procedure for replacing the left
bulb. The procedure for working
on the right side is the same.
Turn slipstream deflector 1 out.
Remove screw 2 and work
side cover 3 to the rear and
remove.
Remove screw 1.
Switch on the ignition and raise
the windscreen to its highest
position.
Remove screw 2 and work
hand protector 3 to the side
to remove.
Switch off the ignition and
wait until the windscreen has
moved to its lowest position.
8
139
z