Clip on retaining clip 1 holding
the sensor cable to the brake
line.
Secure new cable tie 2.
Remove the adhesive tape
from the wheel rim.
Firmly pull the handbrake lever
several times until a pressure
point is perceptible.
Hold the front-wheel cover in
position and install bolts 1 on
left and right.
Remove the rear wheel
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
If applicable, remove the cases.
Remove screws 1 on left and
right.
Remove the number-plate car-
rier.
Engage first gear.
8
135
z