Insert the ABS sensor into its
bore and install screw 1.
Remove the adhesive tape
from the wheel rim.
Operate the brake several
times until the brake pads are
bedded.
Firmly compress the front forks
several times.
Tighten right axle clamping
screws 1 to the specified tight-
ening torque.
Clamp of quick-release
axle
Tightening sequence: Tighten
screws six times in alternate
sequence
19 Nm
Removing rear wheel
Make sure the ground is level
and firm and place the mo-
torcycle on a suitable auxiliary
stand.
8
109
z