BMW F 800 GS Adventure Rider's Manual page 115

commends the BMW Motorrad
auxiliary stand.
OE
with centre stand
Make sure the ground is level
and firm and place the motor-
cycle on its centre stand.
Use basic stand with front
wheel holder. The basic
stand and its accessory
parts are available from your
BMW Motorrad dealer.
Loosen the fastening screws 1.
Push the two adapters 2 apart
until the telescopic forks fit
between them.
Use locating pins 3 to set the
front-wheel stand to the de-
sired height.
Centre the front-wheel stand
relative to the front wheel and
push it against the front axle.
Align the two adapters 2 so
that the telescopic forks are
securely seated.
Tighten securing screw 1.
Apply uniform pressure to push
the front-wheel stand down
and raise the motorcycle.
OE
with centre stand
ATTENTION
Centre stand retracts if
vehicle lifted too high.
Risk of damage to parts if vehicle
topples.
When raising the vehicle, make
sure that the centre stand re-
mains on the ground.
If necessary, adjust the height
of the front-wheel stand.
8
113
z