Table of Contents
Advertisement
Power supply
Setup
It has been found that counterfeit battery
packs which look very similar to genuine
product are made available to purchase in
some markets. Some of these battery packs
are not adequately protected with internal
protection to meet the requirements of
appropriate safety standards. There is a
possibility that these battery packs may lead
to fire or explosion. Please be advised that we
are not liable for any accident or failure
occurring as a result of use of a counterfeit
battery pack. To ensure that safe products are
used we would recommend that the genuine
Panasonic battery pack is used.
≥ Be aware that many batteries sold at
extremely cheap prices or in situations where
it is difficult to verify the actual products before
purchase have proven to be counterfeit.
Charging the battery
When this unit is purchased, the battery is not
charged. Charge the battery before using this
unit.
≥ If the DC cable is connected to the AC
adaptor, then the battery will not be
charged. Remove the DC cable from the AC
adaptor.
1
Connect the AC cable to the AC
adaptor and the AC outlet.
2
Put the battery on the battery
mount by aligning the mark, and
then securely plug it in.
≥ The output plug of the AC cable is not
completely connected to the AC adaptor
socket. As shown in A, there is a gap.
∫ Charging lamp
Lights up: Charging
Goes off:
Flashing:
≥ Battery charging time (l 20)
≥ We recommend using Panasonic batteries.
(l 10)
≥ If you use other batteries, we cannot guarantee
the quality of this product.
Inserting the battery
Push the battery against the battery
holder and slide it until it clicks.
Removing the battery
A
While sliding the BATTERY lever,
slide the battery to remove it.
≥ Hold the battery with your hand so it does not
fall.
≥ Before removing the battery, be sure to set the
OFF/ON switch to OFF and check that the
status indicator is off.
Charging completed
The battery is over discharged
(discharged excessively). In a while,
the lamp will light up and normal
charging will start.
When the battery temperature is
excessively high or low, the CHARGE
lamp flashes and the charging time will
be longer than normal.
Setup
19
LSQT1363
Advertisement
Table of Contents
